# This file contains common pin mappings for Anet A8 printer from 2016
# and 2017. To use this config, the firmware should be compiled for
# the AVR atmega1284p.

# Note that the "make flash" command does not work with Anet boards -
# the boards are typically flashed with this command:
#  avrdude -p atmega1284p -c arduino -b 57600 -P /dev/ttyUSB0 -U out/klipper.elf.hex

# See the example.cfg file for a description of available parameters.

[stepper_x]
step_pin: PD7
dir_pin: PC5
enable_pin: !PD6
step_distance: .01
endstop_pin: ^!PC2
position_endstop: -30
position_max: 220
position_min: -30
homing_speed: 50

[stepper_y]
step_pin: PC6
dir_pin: PC7
enable_pin: !PD6
step_distance: .01
endstop_pin: ^!PC3
position_endstop: -8
position_min: -8
position_max: 220
homing_speed: 50

[stepper_z]
step_pin: PB3
dir_pin: !PB2
enable_pin: !PA5
step_distance: .0025
endstop_pin: ^!PC4
position_endstop: 0.5
position_max: 240
homing_speed: 20

[extruder]
step_pin: PB1
dir_pin: PB0
enable_pin: !PD6
step_distance: .0105
nozzle_diameter: 0.400
filament_diameter: 1.750
heater_pin: PD5
sensor_type: ATC Semitec 104GT-2
sensor_pin: PA7
#control: pid
#pid_Kp: 2.151492
#pid_Ki: 0.633897
#pid_Kd: 230.042965
min_temp: 0
max_temp: 250

[heater_bed]
heater_pin: PD4
sensor_type: ATC Semitec 104GT-2
sensor_pin: PA6
#control: watermark
min_temp: 0
max_temp: 130

[fan]
pin: PB4

[mcu]
serial: /dev/ttyUSB0

[printer]
kinematics: cartesian
max_velocity: 300
max_accel: 1000
max_z_velocity: 20
max_z_accel: 100

[display]
lcd_type: hd44780
rs_pin: PA3
e_pin: PA2
d4_pin: PD2
d5_pin: PD3
d6_pin: PC0
d7_pin: PC1
up_pin: PA1
analog_range_up_pin: 9000, 13000
down_pin: PA1
analog_range_down_pin: 800, 1300
click_pin: PA1
analog_range_click_pin: 2000, 2500
back_pin: PA1
analog_range_back_pin: 4500, 5000
#kill_pin: PA1
#analog_range_kill_pin: 400, 600

#*# <---------------------- SAVE_CONFIG ---------------------->
#*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated.
#*#
#*# [extruder]
#*# control = pid
#*# pid_kp = 20.302
#*# pid_ki = 0.691
#*# pid_kd = 149.217
#*#
#*# [heater_bed]
#*# control = pid
#*# pid_kp = 69.898
#*# pid_ki = 1.277
#*# pid_kd = 956.729