acceleration_infill = 2000
acceleration_print = 1500
acceleration_wall = 800
infill_pattern = ='lines' if infill_sparse_density > 50 else 'cubic'
infill_sparse_density = 50
ironing_enabled = False
ironing_only_highest_layer = True
jerk_infill = 20
jerk_print = 8
jerk_support = 20
jerk_wall = 4
material_flow_layer_0 = 105
material_print_temperature = 205
raft_margin = 5
retraction_amount = 4
retraction_speed = 50
skirt_brim_speed = 21.0
speed_infill = 100
speed_print = 80
speed_support = 80.0
speed_topbottom = 41.0
speed_travel = 300.0
speed_travel_layer_0 = 200.0
speed_wall = 40.0
speed_wall_0 = 30.0
support_angle = 60
support_brim_width = 2
support_tree_angle = 45
support_tree_branch_distance = 2
support_use_towers = True
wall_0_material_flow = 95
xy_offset_layer_0 = -0.15
z_seam_type = sharpest_corner

acceleration_enabled = True
adhesion_type = raft
adhesion_z_offset = 0.08
jerk_enabled = False
layer_height = 0.1
layer_height_0 = 0.2
support_tree_enable = True