1. What is a Motion Sensor Switch? Motion sensor switches have been on the market for a long period of time, however (while they are typically used in commercial building) they haven't become mainstream in home systems. In some ways, this could be considered to be an error. In other words, these switches are an excellent idea and can perform well in a variety of ways. They're not the best option in all other circumstances however, due to the reasons mentioned below.
2. What to do if don't want to use a motion sensor switch: In general, you should install the switch just as it was designed. This will avoid any problems with installation. Sometimes, however, a technician could make a mistake and fail to know how to put the switch in place - and that's why you need to know the best way to set it up. It's possible to make an error and not cover the reset switch. It could be necessary to replace the wiring in the event that you don't have a cover for the ground or power leads. Don't do it , just leave the wires in place, and then have your motion sensor switch installed as you would normally.
3. How to mount an old Switch If it's Still in Good Condition: To avoid mounting problems You can purchase an old motion sensor switch and remove the cover plate. Then you can stick it on the wall. This is a good option for switches made of steel, brass or any other material that is not as susceptible to corrosion. This won't work if your switch is made of aluminum. You can take off the cover plate if the switch is made of wood or plastic (or any other material less likely to corrosion). Fix it to the wall.
4. Screws are also a possibility when there is no cover plate. If you're not sure what you can do safely, you could use some metal screws to secure the sensor switch. To make sure that the screw does not go out, you may need to use some electrical tape. If you're not sure what screws to use, you can use electrical tape on the screw heads so that you can utilize them if you want to.
5. How to Make your Motion Sensor Light Switch Automatically On and Off: Once you've installed the sensor switch it's time to put it to the proper mode. The lights will know when there is something in the area by using two different modes. The first is activated by movement, and the second by the presence of something in the vicinity. Normally your motion sensor switch will detect the movement and light.
6.  
7. Finally, hook up the wires and sensors to your new switch, and test to make sure it works as it should. Then, https://sites.google.com/view/occupancy-sensor/ can either remove the old switch and connect the new one. Or, simply connect the wires back to the switch that was previously used and put the motion sensor switch back in place. The same procedure is followed for installing the new switch in the same way as the older one.
8.  
9. Website: https://od.lk/f/OTRfNDcwMzE0ODNf